StrombergCarlson.com • 231.947.8600
Your bunk ladder comes assembled with the large hooks to
mount over the top of your bunk rail. If you prefer to mount into
the side of your bunk rail or a different structural support, please
follow the below instructions:
1. Remove the bolts and large hooks from the top of your bunk
ladder, saving for later use.
2. Using the same bolts, install the small hooks onto the top of
your bunk ladder.
3. Locate the structural surface you plan to mount to. Assemble
the front and back of your mounting bracket pieces as
shown (Figure 1). Place your mounting bracket at the
location you’d like one side of your ladder to mount. Using
the provided screws, attach the bracket to the mounting
surface. Measure 11” horizontally from your bracket and
INS-BUNKLADDER-C 06.18.2021
Bunk Ladders
Models: LA-460, LA-460B, LA-466, LA-466B
Bunk Ladders LA-460, LA-460B, LA-466, LA-466B
FIGURE 1
Thank you for purchasing the RV Bunk Ladder by Stromberg
Carlson.
Please read all directions prior to installation. When
assembled and used properly, this ladder will provide many
years of trouble free service. This kit contains components and
hardware for one complete bunk ladder. Complete the following
easy steps and it will be ready for use!
Tools Needed
#2 Phillips screwdriver
Tape measure
Pencil
Carton Contents
(1) Bunk Ladder – 60” or 66” with (2) large hooks and
(2) mounting bolts attached
(1) Hardware bag containing (4) screws, (2) small hooks and
(2) mounting brackets assemblies
Hardware Bag
Large Hooks and Bolts
To Next Page
Need help?
General
