Stay alert, watch what you are doing, and use common sense when operating the tool. Do not use
the cart while you are tired or under the influence of drugs, alcohol, or medication. A moment of
inattention while operating the cart may result in serious personal injury.
Dress properly. Do not wear loose clothing, dangling objects, or jewelry. Keep your hair, clothing
and gloves away from moving parts. Loose clothes, jewelry, or long hair can be caught in moving
parts. Air vents on the tool often cover moving parts and should be avoided.
Wear the proper personal protective equipment when necessary. Use ANSI Z87.1 compliant
safety goggles (not safety glasses) with side shields, or when needed, a face shield. Use a dust
mask in dusty work conditions. Also use non-skid safety shoes, hardhat, gloves, dust collection
systems, and hearing protection when appropriate. This applies to all persons in the work area.
Do not overreach. Keep proper footing and balance at all times.
CART USE AND CARE
Do not force the cart. Products are safer and do a better job when used in the manner for which
they are designed. Plan your work, and use the correct product for the job.
Check for damaged parts before each use. Carefully check that the cart will operate properly and
perform its intended function. Replace damaged or worn parts immediately. Never operate the cart
with a damaged part.
Do not use a product with a malfunctioning switch. Any power tool that cannot be controlled with
the power switch is dangerous and must be repaired by an authorized service representative
before using.
Disconnect the power/air supply from the product and place the switch in the locked or off position
before making any adjustments, changing accessories, or storing the tool. Such preventive safety
measures reduce the risk of starting the tool accidentally.
Store the cart when it is not in use. Store it in a dry, secure place out of the reach of children.
Inspect the tool for good working condition prior to storage and before re-use.
Use only accessories that are recommended by the manufacturer for use with your cart.
Accessories that may be suitable for one product may create a risk of injury when used with
another tool. Never use an accessory that has a lower operating speed or operating pressure than
the tool itself.
Keep guards in place and in working order. Never operate the cart without the guards in place.
Do not leave the tool running unattended.
Specific Operation Warnings
Do not exceed the rated load capacity.
Be aware of dynamic loading. A sudden loading movement may briefly create an excess load
causing product failure.
Do not allow riders.
Use only on a hard level surface.
Inspect before each use. Do not use if parts are damaged.
To Next Page
Loading...
