Why is my Strongway Jacks leaking fluid?
If your Strongway jacks leak fluid, it is likely that a seal or another component is worn or damaged. You should inspect the jacks and replace any worn or damaged parts.
What to do if Strongway Jacks lowers by itself?
If, once lifted, the truck lowers by itself when using Strongway jacks, it could be due to several reasons: * Air in the oil. In this case you should see 'BLEEDING THE AIR'. * A worn O-ring in the ram cylinder or the pallet jack being loaded beyond its capacity. In this case, replace the O-ring (refer to "Seal and 0- Ring Replacement") and reduce the load to within the jack's capacity. * Damaged push rods and/or linkages. In this case, replace the damaged parts. (It is recommended that an authorized service center perform this work.)
What to do if Strongway Jacks forks do not descend?
If the forks on your Strongway jacks do not descend, there could be a few reasons: 1. The piston rod may be deformed. If so, replace the piston rod and cylinder. 2. The piston rod may be rusted. Try lubricating or replacing the rod. Remember to keep the jack in a lowered position when it is not in use. 3. The handle tube, nut, or chain may be broken or missing. If any of these parts are broken or missing, replace the handle tube.
Defines the specific applications and usage conditions for the pallet jack.
Lists the components included in the product packaging.
Details the physical and performance characteristics of the pallet jack.
Provides essential safety warnings for operating the pallet jack.
Covers safety measures for the work environment and operator.
Advises on proper handling, checking for damage, and storage.
Lists critical warnings related to operating the pallet jack, like load capacity.
Lists the tools needed to assemble the pallet jack.
Step-by-step guide for assembling the pallet jack.
Crucial warnings before and during pallet jack operation.
Explains the three positions of the control lever for operation.
Procedure for adjusting the control handle for proper function.
Guidance on routine maintenance tasks for the pallet jack.
Procedures for checking oil, lubrication, and bleeding air.
Detailed steps for replacing seals and O-rings in the hydraulic system.
Identifies failures and provides corrective actions for the pallet jack.
Visual representation of pallet jack components with item numbers.
Comprehensive list of pallet jack parts with quantities.
Contact details and requirements for ordering replacement parts.
Details the warranty coverage, duration, and limitations.
Requirements for the purchaser to make a warranty claim.
Defines remedy limits and user's assumption of product use risk.
Specifies the legal jurisdiction and state laws applicable to the warranty.
General| Product Type | Hydraulic Bottle Jack |
|---|---|
| Capacity (tons) | 20 |
| Material | Steel |
| Capacity | 20 tons |
| Minimum Height | 9.25 inches |
| Min. Lift Height (in.) | 9.5 |
| Max. Lift Height (in.) | 18.125 |
To Next Page
