7
Programming notice:
ASQ: (Automatic Squelch Control)
Beep:
This funciont basically emit an audible beeo when a feature is turned on or
off, for example moving the NB setich to NB+ switch positon.
Time out timer:
is used to set transmitting limit time. When pressing PTT key at a single
time longer than the due time setup in advance, the radio would stop trans-
-mitting automatically and the speaker will emit a voice prompt until the PTT
key is released. Then, the radio can transmit again
The programming software for the SR-447HPC2 is available for down
load on our website www.strykerradios.com.
A special USB cable is
required to program your radio. You may purchase this cable from our
website as well.
RB
TSQ
Rep
Public data
REP frequency
Public data
REP frequency
when Public setting is OFF, the busy channel lockout and RB setting can set
different for each channel. when Public setting is ON, the busy channel
lockout and RB setting are same for each channel.
Suppressed undesirable back-ground noises when no communication.
Squelch does not effect neither sound or transmission power, but allows
a considerable improvement in listening comfort.
CTCSS and DCS code avaible for each single channel, when one
channel set a CTCSS or DCS code, you can hear on this channel
only when the other radio set same code on this channel. when one
channel set TSQ off, you can hear other radio no matter if they set
any CTCSS/DCS code. TSQ is often used to commnuicate within
team members.
This function lets you choose from a total of 8 roger beep. the RB tones
are programmable
REP setting is choose offset direction + or - or OFF.
You can programming the offset frequency , default value is 100Khz.
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
8312 Sidbury Rd.; Wilmington, NC 28411 - (800) 507-0482 / (910) 686-4281
To Previous Page
Loading...
Need help?
General
