Need help?Do you have a question about the Stuart SMP10 and is the answer not in the manual?
Describes the IEC socket and mains lead connection for the apparatus.
Details on replacing the mains lead with correct specifications for safety.
Instructions for unpacking and applying the instruction label to the unit.
Explains the plateau function for pre-heating and holding temperature.
Instructions on positioning the unit and extending feet for optimal viewing.
Connecting power and switching on the unit, observing the display.
How to prepare the sample by placing it in a glass capillary tube.
Steps to set and confirm the plateau temperature using the control buttons.
Instructions for inserting the sample tube into the heating block.
Starts the heating process to the plateau and then to the melt point.
Stops the unit after melt, initiates cooling, or restarts plateau.
How to clean the instrument with a damp cloth and mild detergent.
Steps to remove the sample chamber cover for thorough cleaning.
Emphasizes that repairs must be done by qualified personnel only.
Information on fuse locations, types, and correct replacement values.
Details the 3-year warranty against defects in material and workmanship.
Lists conditions like misuse or unauthorized repair under which warranty is void.
Lists key technical details like temperature range, resolution, and dimensions.
Lists EU directives the product complies with, such as EMC and Low Voltage.
Lists harmonised standards the product meets for conformity.
General| Type | Melting Point Apparatus |
|---|---|
| Temperature Resolution | 0.1°C |
| Display | Digital LCD |
| Sample Capacity | Up to 3 samples |
| Dimensions | 160 x 220 x 170 mm |
| Heating Rate | 1°C/min to 10°C/min in 1°C increments |
| Lighting | LED Illumination |
| Power Supply | 230V, 50Hz |
To Next Page
