E-8
The Repeat function also applies to programmed track playback.
To repeat programmed tracks
1. During program play, press REPEAT BUTTON (#6) once will repeat the specifically
programmed tracks.
2. Press the REPEAT BUTTON (#6) again will repeat all the programmed tracks.
3. Press the STOP BUTTON (#9) twice to cancel program playback.
PHONO OPERATION
Please Note - Before Use
-
Remove the stylus protector.
-
Be sure that the TONE ARM (#29) is unlocked
and free to move from the TONE ARM REST
(#31) prior to operating. Lock the TONE ARM
(#29) in place again when not in use.
1. Rotate the FUNCTION SELECTOR (#2) to
select the PHONO mode
2. Raise the turntable wood cover.
3. Place a record on the TURNTABLE PLATTER (#25), use the 45 RPM ADAPTER (#26) if
required.
4. Set the RPM SPEED SELECTOR (#30) to the proper position depending on the record
to be played.
5. Lift the TONE ARM (#29) from the TONE ARM REST (#31) by
using the LIFT LEVER (#27) and slowly move it over the record.
The TURNTABLE PLATTER (#25) will start to rotate.
6. Place the TONE ARM (#29) to the desired position of the
record.
7. Adjust the volume to the desired level.
8. At the end of record, the platter will automatically stop spinning.
Lift the TONE ARM (#29) from the record and return it to the TONE ARM REST (#31).
9. To stop playing manually, lift the TONE ARM (#29) from the record and return it to the
TONE ARM REST (#31).
NOTE:
Certain types of records may have an auto-stop area outside the preset limit, so the
turntable may stop before the last track finishes. If this occurs, set the AUTO-STOP
SWITCH (#28) to the “OFF” position. This allows the record to play to the end, but please
note that it will not stop automatically. You must manually raise the TONE ARM (#29) and
place it back in the TONE ARM REST (#31) and then turn off the power to stop the
turntable from spinning.
To Next Page
Loading...