E-7
PLAYING A CD
1. Rotate the POWER/VOLUME ON/OFF SWITCH (#5) to turn on the SB6080.
2. Rotate the FUNCTION SELECTOR (#2) to select CD mode.
3. Press CD DOOR OPEN/CLOSE BUTTON (#8) to open the disc tray.
4. Carefully place an audio CD with its label side upward on the tray.
5. Press CD DOOR OPEN/CLOSE BUTTON (#8) to close the tray, the disc will start
playing the first track once loaded and the PLAYBACK LED INDICATOR (#21) will
light.
6. To pause playback, press the PLAY/PAUSE BUTTON (#7). To resume playing press
PLAY/PAUSE BUTTON (#7) again.
7. You can choose to play your favorite track directly by pressing either the F.
(FORWARD) SKIP BUTTON (#16) or B. (BACKWARD) SKIP BUTTON (#14). The LED
DISPLAY (#11) will indicate the correct track number selected.
8. To locate a particular section within a track, press and hold the F. (FORWARD) SKIP
BUTTON (#16) or B. (BACKWARD) SKIP BUTTON (#14) until the section is found.
Release the button to continue playing your selection.
9. To stop playing, press STOP BUTTON (#9).
10. When you wish to turn off the CD Player, rotate the POWER/VOLUME ON/OFF
SWITCH (#5) to the OFF position
REPEAT MODE
REPEAT 1
When the REPEAT BUTTON (#6) is pressed once, the REPEAT ONE INDICATOR
(#18) on the LED DISPLAY (#11) will light
. The current track will be played repeatedly.
REPEAT ALL
When the
REPEAT BUTTON (#6)
is pressed twice, the REPEAT ALL INDICATOR (#19)
on the LED DISPLAY (#11) will light. The whole disc will be played repeatedly.
CD PROGRAM PLAY MODE
This function allows the CD tracks to be played in programmed sequence.
NOTE: Program can only be set in STOP mode.
1.
Load the CD Disc you wish
to program.
2.
Make sure the unit
is in
STOP
mode.
3.
Press the PROGRAM BUTTON
(#17)
once, location "P01"
will
show
on
the LED DISPLAY
(#11
)
.
4. Press F. (FORWARD) SKIP BUTTON (#16) or B. (BACKWARD) SKIP BUTTON (#14)
until the desired track number is reached.
5.
Press the PROGRAM BUTTON
(#17) to
store
the selection.
6.
Repeat the
(4) to (5)
steps until
you
have entered
all
the
tracks you want to program.
7. To
play the stored sequence, press
the PLAY/PAUSE BUTTON (#7). The PROGRAM
PLAYBACK LED INDICATOR (#20) will light.
8.
After
all
memory tracks have
been
played, the CD will
stop automatically.
NOTES
:
•
When 20 tracks of
CD music
have been
pr
ogrammed, the
memory is full “FUL” will indicate
on the LED DISPLAY(#11). Press PLAY/PAUSE BUTTON (#7) to start the program playback.
•
If you
want to cancel
the
program memory, press the STOP BOTTON (#9)
twice during
playback or change to other mode or turn off the power.
To Next Page
Loading...