STUDER INNOTEC HP-COMPACT
User manual HP-COMPACT V3.0 E 9
3.4 Connection Plan
A Battery +/- Connection terminal (M8) for battery cable (HPC 4024/5048/
7048 with fuse)
B Reserved
C Remote contr. Connection terminal for Remote Control RCC-01
D Transfer delay Slide switch for Transfer Delay
E Equalize Slide switch for equalization of the Battery
F Temp. Connection terminal for Temperature sensor CT-35 and/or
Remote Power Sharing RPS-01
G Aux. Contact Connection terminal for Auxiliary Contact
H AC Input Connection terminal for AC-input
J ID Plate Identification plate with Technical data and Serial number
K AC Output Connection terminal for AC-output
L Reserved
M Hole Pass through hole for RCC-01, CT-35 and RPS-01
N Protection Thermal circuit breaker 30A (50A for HPC7048) for the
Transfer system
3.5 Cabling
Connecting the HP-COMPACT is a very important step of the installation. You must take
care that all connection work is carried out in a clean and correct way and that under no
circumstance a cable is connected to a wrong terminal.
Connecting of the HP-COMPACT must be carried out in the following order. In case of
dismantling this order must be reversed.
LN
LN
Battery
AC in
AC out
Auxiliary
contact
Remote
control
RCT-01
temperature sensor CT35
A
N
H G
K
B
L
D
C
F
J
M
remote power sharing RPS-01
E
To Next Page
Loading...
