22
GB
NOTIFICATION SIGNS
The half-power mode has been activated by the manual control.
[ Flashing symbol ]. Monitor mode is activeted.
The AC mains voltage is too low. The battery charger goes into half-power mode.
The message disappears when the mains voltage falls within the nominal range
again. (This indication appears when the battery charger is turned off even under
normal voltage supply conditions).
The battery charger is reducing power because of a high ambient temperature. The
message disappears as soon as the condition which caused the problem is no
longer present. If this message appears frequently check whether the battery
charger has been installed properly.
The temperature measured by the battery sensors (optional) is outside the range
determined for the charge (-20/+55°C). The output voltage of the battery charger
becomes 12.8V (25.6V in the 24V models) so that the batteries are not damaged.
This message disappears when the battery temperature falls back within the cor-
rect range.
CAN BUS communication problem. The system has found a rate of communication
errors which is higher than normal.
If this message appears frequently, check whether the CAN network wiring has
been carried out properly.
NOTIFICATION SIGNS
PROBLEMS WITH AUTOMATIC RESET
To Next Page
Loading...
Need help?
General
