Need help?Do you have a question about the Studer next 3 and is the answer not in the manual?
General| DC Voltage | 48 V |
|---|---|
| AC Voltage | 230 V |
| Frequency | 50 Hz |
| Output Power | 3 kW |
| Input Voltage | 48 V |
| Protection | Overload, short circuit |
| Humidity | 95% non-condensing |
Studer disclaims responsibility for damage from improper installation, operation, or maintenance.
Details on how to store the product and its included contents.
Provides essential dimensions and fixing points for installation.
Specifies suitable locations and conditions for mounting the device.
Guidelines for proper earthing and insulation requirements.
Explains connections for CAN BMS and RS485i communication.
Details on connecting the battery and solar PV inputs.
Outlines AC wiring, circuit breakers, RCCB, and SPD.
Describes the requirement for an nx interface in the communication bus.
Explains various LED indicators and their meanings on the display system.
Details on navigating the nx interface for setup and monitoring.
Describes the guided configuration process for initial setup.
Explains 3-phase and parallel combinations for multi-unit systems.
Guidance on product maintenance and proper disposal procedures.
To Next Page
