Welcome to the world of
STUDIO
LOGIC
MIDICONTROLLERS.
the MIDI MP-113/MP-117 is a MIDI Pedalboard controller with a simple yet versatile
software.Studio
and stage musicians alike
will
appreciate
the
added
flexibility
of
acces-
sing MIDI events by foot, both for playing traditional bass lines and for triggering other
MIDI effects and devices.
TECHNICAL DATA
The MP-113/MP-117 pedalboard is composed of:
•Pedalboard with 13 (MP-113) or 17 (MP-117) dynamic keys
• Top panel with the following buttons: MIDI channel. Program Change, Bank Select and
Transpose ^
•
1
zone
with
full
extension
• Numerical keypad corresponding to the pedals starting from the first low C.
•
Rear
panel:
1
output
MIDI,
DC
feeding
input,
1
signaling
led.
CONNECTIONS
1)
Connect
the
AC
adapter cable
to
the
power
input
jack.
Make
sure
that
the
AC
adapter
corresponds
to
the correct voltage
output.
The
MP-113/MP-117
will
accept
an
adapter
that has a rating of 9V DC with a positive polarity and has a minimum current of 200 mA.
2) Connect MIDI cable/s to the MIDI input on your sound sources.
3) Connect the DC feeding cable to the MIDI pedalboard. The default channel is MIDI no.l.
TOP PANEL
The figure shows the control panel on top of the pedalboard, with four function buttons.
To assign values and adjust parameters, use the numerical keypad located on the PEDAL-
BOARD
octave. Starting from
the
LOW
C,
you
will
have
the
following
pattern:
MIDI
FUNCTIONS
You should bear in mind the main functions of your Pedalboard.
A few seconds after switching on, the instrument is ready to send the desired MIDI data
and
the
keyboard
will
be
sending on
MIDI
channel no. 1.
Operations must be carried out sequentially. To assign values to commands, hold the spe-
cific button, enter the number on the keypad and then release the button. If there are any
keys
pressed
on
the
keyboard,
no
command
will
be
accepted.
The
same
happens when
the
Sustain pedal is down. On the contrary, if you press any key no sound is produced, since
the function keys on the central octave are enabled.
When
you switch on your instrument,
it
will
send
the
following
data:
•VOLUME = VALUE 127
•PITCH BEND = VALUE 64
To Next Page
Need help?
General
