Studiologic SL-990 User Manual

FEATURES
• 88 Key Keyboard with ivory
finish keys
•"Regulated" weighted ham-
mer action for true piano
feel
• One zone
• MIDI program change Button
•MIDI Bank Select Button
•One MIDI Out Jack
•One Sustain Jack
•9v DC 200mA power
input Jack
•On/Off switch
CONNECTIONS
1. Connect the power adap-
ter to the power supply
input of the SL-990. The SL-
990 is supplied with a 9vDC,
2OOma, tip positive (+)
adapter.
2. Connect a MIDI cable
from the MIDI Output of the
SL-990 to the MIDI imput
jack of your MIDI module or
Keyboard. NOTE; The SL-990
is capable of providing
power through the MIDI
connection, if your module
is designed to be able to
make use this. You may
need a special MIDI cable,
with all 5 pins connected
end to end. Ask your retailer
for this cable, if you require it
3. Connect the sustain pedal
to the sustain input jack.
The SL-990 requires a
sustain pedal with a "nor-
mally open" circuit, such as
the FATAR PS-100 or the
VFP-1/10 (piano style)
sustain pedals.
4. The SL-990 will function
on power-up as a one zone
MIDI master controller key-
board transmitting only on
channel one. You must enter
the program change, bank
select and velocity curve
(shape) parameters after
power-up, please see the
preceding sections for
instructions en how to
accomplish these changes.

Studiologic SL-990 Specifications

General

Brand	Studiologic
Model	SL-990
Category	Electronic Keyboard
Language	English

Summary

SL-990 Features

SL-990 Connections

Power Adapter Connection

Connect the power adapter to the SL-990's power input jack. Use the supplied 9vDC, 200mA tip positive adapter.

MIDI Cable Connection

Connect the SL-990's MIDI Out to your MIDI module's input. A special 5-pin connected cable may be needed for power passthrough.

Sustain Pedal Connection

Connect a sustain pedal with a normally open circuit, like the FATAR PS-100 or VFP-1/10, to the sustain input jack.

Master Controller Functionality

On power-up, the SL-990 acts as a one-zone MIDI master controller transmitting on channel one. Configure parameters after power-up.

Program Change Function

Bank Select Function

Velocity Curve (Shape) Settings