TO MIDI = Merged MIDI data are sent to the MIDI OUT
TO USB = Merged MIDI data are sent to USB
TO MIDI+USB = Merged MIDI data are sent to both USB and MIDI Out
To filter (cut out) some MIDI message (besides the standard ones) when merging a MIDI in source
to the selected destination.
SLIDER MODE - DIRECT/SNAP
The 9 Sliders (Drawbars in Organ mode) can have two different way of operate, to be selected in
the related Global Edit page, according to your preferences and playing needs.
Selecting the DIRECT mode, when a Slider/Drawbar is moved, the new value corresponding to the
physical position is immediatly read and sent to the Sound generation, allowing to instantly input
the new value, from 0 to 8 in Drawbars-Organ mode and from 1 to 127 in Slider mode, either for
Synth parameters and MIDI assignable values.
Selecting the SNAP mode, when a Slider/Drawbar is moved, new values are read and updated one
after the new position corresponds to the original stored value; as an example, if the Cutoff value of
a Sound was 100, the Slider will input a new value only after you reach the original 100 position.
CLICK KEY ON / CLICK KEY OFF
The Key Click adds the typical noise associated with the tone wheels vintage organ's technology
that became part of their sound. With the related Key ON and key OFF controls you can set the
level of the noise according to your taste: this Global Edit function allows to control the Click level
separately for Key on and Key Off, in order to reach the desired effect when playing the keys and
FAST/SLOW PERCUSSION VOLUME
This GLOBAL function allows to control the Percussion Volume; the original Tonewheel Organs
had a direct panel control for the Percussion Volume, but it was made of 2 steps: SOFT or
NORMAL- With this Global parameter you have a continous control on the Percussion level with
64 values, independently associated to the Fast and Slow decay.
User manual - Numa Compact X SE https://www.studiologic-music.com/support/articles/ncxse_manual/?l...
20 di 32 01/03/2024, 13:41