New implementation relating to the ORGAN model with continuous control from 00 to 127 which
reproduces in each Drawbar, the harmonics due to the electromagnetic interference (crosstalk)
between the adjacent tone wheels as well as the signal passage between the numerous wiring
harnesses of the original instruments. Leakage affects both Organ Models.
MIN/MID/MAX selection of the upper part of the upper rotor of the Rotary, referred to the three
pulleys available on the original Leslie. This control allow to vary the maximum speed based on
which pulley is connected to the drive belt.
This function has been integrated into the Numa Manager application. However, if you still want to
use the legacy method, do the following:
Connect the Numa Compact to your computer via USB;
Open an application that can send/receive Sysex messages;
Once the function is selected, rotating the encoder to choose SEND or RECEIVE;
Select Numa Compact as target device;
To send data to your computer, click the encoder when selecting SEND, confirm YES and wait until
To receive the data back to your instrument, click the encoder when selecting RECEIVE; then send
the Sysex file through the application.
The Factory Reset is divided into:
PROGRAMS: which restores all Programs to factory settings.
GLOBAL which restores all parameters except the Programs.
It could make you lose custom settings or programming and the function should be done very
carefully. To protect the user from unwanted reset, a caution YES/NO message appears when
trying to reset the unit, allowing to confirm or not the factory restore.
User manual - Numa Compact X SE https://www.studiologic-music.com/support/articles/ncxse_manual/?l...
21 di 32 01/03/2024, 13:41
To Next Page
Loading...
