EasyManua.ls Logo

Studiologic Numa Compact X SE - Fine Tune, Reverb Send, and Control Assignments; Aftertouch Control

Studiologic Numa Compact X SE
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
UPPER part one or two octaves down, as you could prefer if you select a TENOR sax in
combination with a splitted BASS sound on the left, since the Sax lower and nicer notes could
probably be on the left of the splitted keyboard portion. Simply experiment the setting you prefer
and then store it in the current PROGRAM.
FINE TUNE
This parameter allows to fine-tune the Upper and Lower sounds within a semitone range; it could
be useful to create “beating” sligthly detuned sounds, when assigning a pure Waveform to both
sections (i.e. Sawtooth, Square etc) or enhance some Orchestral 2 sections mix, making it richer.
REV SEND
The function allows to control the amount of signal to be sent to the REVERB processor,
independently for the LOWER and UPPER parts and programmable with different settings for
each PROGRAM. As a typical setting, if you SPLIT the keyboard and assign a BASS sound to the
left, you might want to reduce or minimize the amount of REVERB on the left part, or control the
setting also on the UPPER part to get the desired effect. The MIX potentiometer, on the front
panel, will change the overall reverberation mix (Dry/Wet) with any reverb type selected or send
value.
PEDAL 1 / PEDAL 2
Here you can decide if the pedals are enabled or not for each section (UPPER/LOWER or ZONEA
and ZONE B if the MIDI button is activated).
STICK 1 / STICK 2
As for the pedals, also the Sticks can be enabled separately for the Parts and Zones; please note
that the Stick 2 will be set automatically to AUTO if the related FX-AUTOSET function is set to ON
in the GLOBAL EDIT area. To control the Stick 2 assignment manually, you can set to OFF the FX-
AUTOSET and the function can be switched ON or OFF and stored in the Programs.
AFTERTOUCH
This parameter enables or disables the aftertouch function on the selected Part or Zone; the
function of the Aftertouch will be in most cases similar-same of the Stick 2 modulation control,
adding some kind of vibrato or similar modulation to the sound, according to the setting. Normally
you will set the Aftertouch ON for the UPPER part, that is commonly used for the main musical
part or solo performances, while the LOWER part is normally associated to accompaniments or
bass lines, if the SPLIT is active.
User manual - Numa Compact X SE https://www.studiologic-music.com/support/articles/ncxse_manual/?l...
25 di 32 01/03/2024, 13:41

Related product manuals