Annual maintenance (continuation)
Lubrication of runners
Position a support and a rag to rest
the door.
Tilt the door [photo 5].
Unhook door cables. Attach them in
“standby” mode [photo 6].
Rest the door on the rag.
Slide the glass to the full to access the
runners.
Lubricate both sides of both runners
[photos 7 & 8].
Slide the glass back towards the
hearth, refit the 2 balance weights on
the sliding parts.
Shut the door while pressing the
handling knob downwards [photo 9].
Cleaning of window closing
magnets
Tilt door.
Slide glass ± 4cm.
Run a rag over the magnets (left &
right) to remove any iron filings that
might adhere [photo 10].
Tilt door downwards again while
pressing the handling knob
downwards [photo 9].
To Next Page
Loading...
