StyleCrest Revolv VMC1-75D36N

To Next Page

STYLE CREST, INC.

2450 ENTERPRISE STREET

FREMONT, OH 43420

PHONE: (419) 332-7369

MG-518

ECN 0000-MA 151209

MADE IN USA

GAS FIRED HIGH EFFICIENCY FURNACE

DOWNFLOW & DIRECT VENT (SEALED COMBUSTION)

MODELS:

VMA3-50D36N, VMA3-75D36N,

VMC1-50D36N, VMC1-75D36N,

VMC1-50DV3N, VMC1-75DV3N

INSTALLATION AND SERVICE MANUAL

For installation in:

1. Manufactured Homes

2. Modular Homes/Buildings

3. Site Constructed—Residential (Single Story Dwellings)

FOR YOUR SAFETY

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or

any other appliance.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone in your building.

• Immediately call your gas supplier from a neighbor’s phone.

Follow the gas supplier’s instructions.

• If you cannot reach your gas supplier, call the fire department.

If the information in these instructions is not followed exactly, a fire or explosion may

result causing property damage, personal injury, or loss of life.

: Improper installation, adjustment, alteration, service, or maintenance can cause injury or

property damage. Refer to this manual. For assistance or additional information, consult a qualified

installer, service agency, or fuel supplier.

: Do not use this appliance if any part has been underwater. Immediately call a qualified

service technician to inspect the appliance and to replace any part of the electrical or control system

that has been underwater.

PLEASE READ THESE INSTRUCTIONS PRIOR TO INSTALLATION, INITIAL FIRING, AND BEFORE PERFORMING

ANY SERVICE OR MAINTENANCE. THESE INSTRUCTIONS MUST BE LEFT WITH THE USER AND SHOULD BE

RETAINED FOR FUTURE REFERENCE BY QUALIFIED SERVICE PERSONNEL.

Main Page

Need help?

Do you have a question about the StyleCrest Revolv VMC1-75D36N and is the answer not in the manual?

Summary

I. SAFETY INFORMATION

WARNING: Gas Leak Safety

II. OPERATING INSTRUCTIONS

Gas Leak Response Procedure

Furnace Startup Sequence

Sequential instructions for starting and operating the furnace correctly.

III. GENERAL INSTRUCTIONS AND CLEARANCES

IV. GENERAL INSTALLATION

FUEL PIPING

Regulations and procedures for sizing and installing fuel lines.

GENERAL VENTING REQUIREMENTS

Rules and guidelines for installing the furnace venting system.

ELECTRICAL WIRING

Guidelines for performing electrical wiring for the furnace.

V. STARTING THE UNIT

SEQUENCE OF OPERATIONS

Step-by-step process of the furnace's ignition and operation cycle.

INITIAL START UP

Pre-startup checks and procedures before the first operation of the furnace.

FURNACE CHECKOUT PROCEDURE

Steps for performing a final checkout and testing of the installed furnace.

VIII. TROUBLESHOOTING

Startup and Checkout Familiarization

Emphasizes familiarizing with startup and checkout procedures before troubleshooting.

Diagnostic Features Overview

Explanation of the integrated ignition control's diagnostic capabilities.

Diagnostic Code Interpretation

Explains LED flash codes for system failures and errors.

Troubleshooting Guide Flowchart

A flowchart to guide troubleshooting based on system behavior.

Troubleshooting Complete; Control Failure

Indicates completion of troubleshooting or need to replace integrated control.

APPENDIX - B WIRING DIAGRAMS