Suaoki 9500 - Operation Flow: Basic Functions; Data Transmission Limits; Clock and Stopwatch Functions; Trip Data and Speed Metrics

EN-13
Transmission Range
The data transmission distance between the computer unit and sensor should
not exceed 60cm.
The data transmission distance between the sensor and magnet should not
exceed 3mm.
Operation Flow
[Refer to Diagram 2]
Press SET button to select between Bike A and Bike B. MODE button to confirm
the choice and move on.
Clock
The clock is displayed in chosen format (12H or 24H)
Stopwatch
Press set button to start and then press set button again to stop. Hold set button
for 2 seconds to reset the numbers.
Count Range: 00:00:00~59M:59S:99~99H59M59S
Trip distance (DIST)
Measured in km or mile (according the settings)
Trip time (RIDETIME)
Format HH:MM:SS
Average speed (AVG-S)
Measured in km/h or mph (according the settings)
Maximum speed (MAX-S)
Measured in km/h or mph (according the settings)
Calorie consumption (CALORIE)
Estimated burned calorie according to the trip distance. Measured in KCAL.
Note that this data could be displayed only when trip distance is over 3km.
Carbon offset (CO
2
)
Estimated reduced carbon dioxide emissions according to the trip distance.
Measured in KG. Note that this data could be displayed only when trip distance
is over 3km.
Current temperature (TEMP)
Displayed in preferred unit-°C or °F. Press the SET button to choose.