Operation Guidance
1) How to charge with the DC output ports of this product?
Connect your DC 12V appliances with the 5.5mm 12V DC output port. And your
appliances would be charged automatically.
※ Note: Please check to make sure that your 12V DC appliance supports
charging with the DC port of this product, which is 5.5mm in diameter. You could
confirm it with the manufacturer or seller of your 12V DC appliances.
※ Note:
The 12V DC output voltage falls between 9V~12V. The maximum output
current is 15A. DC output voltage would decrease when battery capacity decreases
over time. If your appliance does not have built-in input voltage stabilizing function,
the product may shutdown when input voltage is too low. Please unplug your
appliance from the product in time. And please charge the product in time.
Protection Mode (DC Output):
Short-circuit/Overpower Protection: If the DC output is short-circuited or
overpowered (Load(s) power>180W), the product will shutdown to protect
itself. Please disconnect the 12V appliances from the product and recharge the
product. This could help restore the product.
Or connect the 12V DC appliances’ car charger and the 12V
DC output port via the cigarette lighter socket.
EN-4
Charge 12V DC appliances (Power <180W) by plug in
the connector (5.5mm in diameter) into the DC output
port directly.
[Front]
To Next Page
Loading...
