To Next Page

To Previous Page

DRAWER DIVIDER

Each drawer of the model 427RG has a divider that can be

easily removed.

To remove, pull the drawer divider forward and pivot the

back edge of the divider away from the back of the

drawer. Reverse the procedure to reinstall the divider.

Refer to the illustration below.

Wine Storage Use & Care 13

subzero.com

Bulk Storage Drawers—Model 427RG

DRAWER REMOVAL

IMPORTANT NOTE:

For model 427RG, you must discon-

nect the control cable before removing the top drawer.

Refer to the illustration below.

IMPORTANT NOTE: Be sure to unload the contents before

removing the drawer.

To remove a drawer from model 427RG, pull the drawer

open until it stops. Lift up evenly on both sides of the

drawer front and pull out, as shown in the illustration

below.

To replace a drawer, raise the front of the drawer up and

place onto the drawer slide tracks. Be sure to engage the

front holes of the drawer slide with the small pegs at the

end of each rail. Reconnect the control cable.

Drawer divider.

Before removing the top drawer of the model 427RG,

you must disconnect the control cable.

Control cable. Drawer removal.

Sub-Zero 424G Use & Care Guide

Other manuals for Sub-Zero 424G