Sub-Zero 601F

47
DOOR PANEL HEIGHT
The height of the door panel can grow beyond
45
1
/4" (1149) and exceed the 80" (2032) overall
height, as long as you stay below the recom-
mended door panel weight limit.
The top illustration shows how the panel may
grow and what you need to consider doing to
finish the area in back of the door panel.
IMPORTANT NOTE: The valance you use to
finish the area behind the door panel must stay
behind the front plane of the finished molding.
45
1
4
(1149)
TO
BOTTOM
OF
DOOR
PANEL
TO
FLOOR
1
4
(6)
1
1
2
(38)
TO WALL
DECORATIVE VALANCE
DECORATIVE VALANCE
CANNOT EXTEND BEYOND
THE FRONT OF THIS PLANE
REMOVABLE MOLDING
BY SUB-ZERO
TOP HINGE
25
(635)
*
FINISHED HEIGHT OF 80" (2032) IS TO TOP OF SUB-ZERO MOLDING
80*
(2032)
10
9
16
(268)
16
9
16
(421)
PANEL
PANEL
10
(254)
4
(102)
OPTIONAL
2
5
8
(67)
4
(102)
TO
9
11
16
(246)
1
2
(13)
FLOOR
TO WALL
25
(635)
BASE MOLDING MUST
BE REMOVABLE
TOE KICK CLEARANCE
The toe kick clearance can vary with the height
of the lower drawer panel; the maximum panel
height is 16
9
/16" (421).
IMPORTANT NOTE: You must keep a minimum
space of 4" (102) clear below the bottom edge
of the lower drawer panel so the unit can be
properly vented. In addition, any decorative base
molding must be removable for possible servic-
ing and cleaning of the condenser.
The bottom illustration shows the area below
the lower drawer where the operating mechani-
cal equipment of the Integrated unit is housed.
KICKPLATE AREA
Base and Tall Models
UPPER VALANCE
Tall Models
The depth of each
Integrated model is
24" (610) from the
front of the unit to its
back. Your design
may necessitate
moving the unit back
or cabinets forward to
achieve a flush fit.
This will require a
minimum rough
opening depth of 25"
(635).
PANEL WEIGHT
The door panel
cannot exceed 40
lbs (18 kg) for 27"
(686) wide units.
For Model 736TC(I)
the door panel
weight limit is 53 lbs
(24 kg).