EasyManuals Logo

Sub-Zero 601R Installation Guide

Sub-Zero 601R
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9
Step 9: Now, level the unit.To adjust the height, turn the
front leveling legs counterclockwise to lower it. Adjust the
rear levelers from the front of the base. Turn the 5/16" hex
bolt clockwise to raise the cabinet, counterclockwise to
lower the cabinet. Refer to illustration 10. When the unit is
leveled properly, or squared off, door adjustments are less
likely to be necessary.
IMPORTANT NOTE: Be sure to reference leveling of the
unit to the floor and not to surrounding cabinetry, by using
the unit main frame and door trim as leveling reference
points. This could effect the operation of the unit, such as
door(s) not closing properly.
Step 10: After the unit has been leveled, install the kick-
plate as shown in illustration 11. Be sure the drain pan is
installed properly.
COMPLETING THE INSTALLATION
Step 8: To complete the installation, first shut off power
to the wall outlet. Plug into a 15 amp grounded outlet
and roll the unit into position under the wood block or sof-
fit. Now you have to connect the ice maker water line.
Remove the 1/4" compression fitting from its plastic bag
and join the water supply line to the solenoid valve.
If desired, the water valve can be removed from mounting
bracket to gain easier access to water connection, as shown
in illustration 8. Purge the line before making the final con-
nection. Illustration 9 applies only to Model 680 and 690.
IMPORTANT NOTE: Turn on the water supply and
check all fittings for leaks. Make certain the electrical
harness is attached to the solenoid.
In areas with water of high mineral content, the use of an
in-line water filter is recommended. Make sure the filter is
positioned and accessible for replacement when necessary.
IMPORTANT NOTE: Let your customer know that the
ice maker will not fill with water immediately, and
that the first three batches of ice produced should be
discarded. Allow 24 hours for proper ice production.
ELECTRICAL
CONNECTION
SOLENOID
VALVE
1
/4" COPPER
SLEEVE
1
/4" COMPRESSION NUT
CAUTION
Protect any finished flooring before moving the unit in
place. All full-size Sub-Zero models are equipped with
rollers, so you can easily move the unit into place. If for
any reason the unit has been laid on its back or side,
you must allow the unit to stand upright for a minimum
of 24 hours before connecting power.
WARNING
To reduce the possibility of the cabinet tipping forward,
the front levelers must be in contact with the floor.
CAUTION
The kickplate must be removed for servicing. The floor
cannot interfere with removal. Refer to label mounted
on kickplate support for height clearance.
Step 11: Replace the grille by reversing the procedure in
Step 6 and turn the power back on. If you’re using a panel
grille, refer to Installing Overlay Grille Panels, page 13.
600
SERIES
Illus. 8 Illus. 9
Illus. 10 Illus. 11

Other manuals for Sub-Zero 601R

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sub-Zero 601R and is the answer not in the manual?

Sub-Zero 601R Specifications

General IconGeneral
TypeRefrigerator
Height84 inches
Energy Star CertifiedNo
Door AlarmYes
LightingLED
Product TypeBuilt-In Refrigerator
Installation TypeBuilt-In
BrandSub-Zero
Model601R
ConfigurationAll Refrigerator
Ice MakerNo
Water DispenserNo
Depth24 inches
Door StylePanel Ready
FinishPanel Ready
Width30 inches

Related product manuals