EasyManuals Logo

Sub-Zero BI-30UG Use And Care Guide

Sub-Zero BI-30UG
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
16
|
Sub-Zero Customer Care 800.222.7820
TROUBLESHOOTING
Troubleshooting
SERVICE INDICATOR
PG
Illuminated. Touch POWER to turn unit off. Verify
condenser area is clean. Touch POWER to turn
unit on. If indicator is still illuminated, call Sub-Zero
customer care at 800-222-7820.
Flashing. Contact Sub-Zero factory certied
service.
13
Flashing. Possible water ow issue. Touch MAX ICE
and ICE MAKER on the control panel simultane-
ously. If indicator ashes again, contact Sub-Zero
factory certied service.
10
Flashing with audible chime. Contact Sub-Zero
factory certied service.
5
Flashing. Replace air purication cartridge. Also,
replace cartridge if there is an odor inside unit.
8
Flashing. Replace water lter. Also, replace lter if
ice tastes bad, is discolored, ice cubes are small or
if water ow from dispenser is slow.
9
Flashing with audible chime. Door has been left ajar
for more than 60 seconds. Close door.
16
UNIT OPERATION
No lights or cooling.
Verify power is on.
Verify electrical power to unit and home circuit breaker
is on.
No lights in refrigerator or freezer.
Door may have been left ajar which has disabled lights to
eliminate excess heat. If lights are out or ‘LOC’ appears
in control panel display, close door for one hour. If lights
are still out, contact Sub-Zero factory certied service.
Frost, condensation or ice build up inside unit.
Verify condenser is clean.
Verify door is closing properly.
Verify door has not been left ajar.
Verify door gasket does not have rips or tears. If it does,
contact Sub-Zero factory certied service.
If icing is heavy, turn unit off and use a hair dryer to melt
ice. Hair dryer should be set on low and kept moving
at all times. Once ice has melted, wipe up water with a
cloth or paper towel.
High temperatures, unit runs excessively or unit giving off
too much heat.
Verify condenser is clean.
Verify door is closing properly.
Verify door has not been left ajar.
Increased ambient temperatures may cause compres-
sors to run longer.
If temperature display shows 38° and 0°, but is not
cooling, unit may be in showroom mode. Contact
Sub-Zero Customer Care at 800-222-7820.

Other manuals for Sub-Zero BI-30UG

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sub-Zero BI-30UG and is the answer not in the manual?

Sub-Zero BI-30UG Specifications

General IconGeneral
BrandSub-Zero
ModelBI-30UG
CategoryRefrigerator
LanguageEnglish

Related product manuals