ADJUSTABLE GLASS SHELVES
IMPORTANT NOTE: Be sure to read the following instruc-
tions before removing or adjusting glass shelves. Use care
when handling glass shelves to prevent breaking the glass
or scratching the interior.
To remove or adjust a glass shelf, first tilt the shelf up at
the front, then lift it up and out of the tracks on the rear
wall of the refrigerator. Refer to the illustration below.
If the door opening is limited to 90°, you may need to take
out door shelves in order to remove the glass shelf. Lift
and pivot the end of the glass shelf nearest the door
upward, and remove.
To replace a glass shelf, insert it in the tracks at the rear
of the refrigerator with the front of the shelf raised slightly.
As you push the shelf in, lower the front of the shelf until it
locks into position.
Built-In Use & Care 16
Glass shelves should warm to room temperature before
immersing in warm water.
Refrigerator Storage
STORAGE DRAWERS
To remove a storage drawer in the refrigerator section,
pull the drawer out until it stops. Lift the font of the drawer
slightly and pull the drawer straight forward. Refer to the
illustration below.
IMPORTANT NOTE: If the door opening is limited to 90°,
the shallow door shelves will need to be removed from the
bottom of the door in order to remove a drawer.
To reinstall, push the drawer slides back into the refrigera-
tor. Align the drawer with the slides, then push the drawer
straight back on to the slides until it stops. Press down-
ward on the front of the drawer to engage the slides.
DOOR SHELVES AND DAIRY COMPARTMENT
The door shelves and dairy compartment are adjustable
within the guides of the door liner. Glass door models do
not have door shelves or a dairy compartment.
To remove a shelf or the dairy compartment, lift it up and
out from the bottom. To reinstall, push it down into the
guides. Refer to the illustration below.
Storage drawer removal. Door shelf removal.
Glass shelf removal.
To Next Page
Loading...
Need help?
General
