subzero.com/specs
|
21
BUILT-IN REFRIGERATION
Custom Panels
FLUSH INSET PANELS
The ush inset application is an overlay model with ush
inset panels. It is not a separate model.
The ush inset design allows custom panels to be installed
ush with adjacent cabinets. Similar to overlay, ush inset
panels are typically created by combining a
3
/4" (19) custom
panel, a .10"
(3) spacer panel and a
1
/4" (6) backer panel.
Refer to the illustrations for overlay panels.
For ush inset panels thicker than
3
/4" (19), a 90° door stop
may be required to prevent interference with adjacent
cabinets. Refer to the full-scale templates at the end of this
guide.
When installing two units side by side, refer to page 17 for
dual ush inset installations.
ICE AND WATER DISPENSER
For models BI-42SD and BI-48SD, the refrigerator door
panel must include a cut-out to accommodate the external
dispenser. The thickness of the panel in this area can range
from
1
/4" (6) to a maximum of 1
1
/8" (29). Refer to the illustra-
tions below.
6
5
/16" (160)
3
/32"
(2)
5
/8"
(16)
12
7
/8"
(327)
Dispenser dimensions.
2"
(51)
1"
(25)
HANDLE
GLASSWELL
Handle placement.
6
5
/16" (160)
3
/16"
(5)
12
7
/8"
(327)
Dispenser dimensions.
BUILT-IN PRO 48 INTEGRATED WINE UNDERCOUNTER
To Next Page
Loading...
