Sub-Zero SZ-CR2 - Page 26

SZ-CR2 25
Function: Enable/Disable Light Relay ON at Door Open.
If this parameter is set to,
(0)
= Light Relay will be ON/OFF functioning
manually and as per Ld parameter.
(1)
= Whenever Door get open, Light Relay
will be ON.
Note:
This parameter is considered only if do0 not equal to
Min.
Max.
Fac.
dd
Function: To reset Compressor1 Run Hours.
When this parameter is set to,
(0)
= Don’t clear Compressor1 Run Hours.
(1)
= Clear Compressor1 Run Hours.
Note:
This parameter is not considered only if CS = C2.
Min.
Max.
Fac.
Function: To reset Compressor2 Run Hours.
When this parameter is set to,
(0)
= Don’t clear Compressor2 Run
Hours.
(1)
= Clear Compressor2 Run Hours.
Note:
This parameter is not considered only if CS = C1.
Min.
Max.
Fac.
Function: Clear Fault Log
When this parameter is set to,
(0)
= Don’t clear Fault Log.
(1)
= Clear Fault Log.
Min.
Max.
Fac.