FORESTER NA. (E)
10-16
5. Remove the air vent plug from the radiator.
HS0178HS0182
Filler neck
Fill up to here
“FULL”
level mark
“LOW”
level mark
6. Slowly pour the coolant and fill to the radiator filler neck and to the
reserve tank’s “FULL” level mark. Do not pour the coolant too quickly, as
this may lead to insufficient air bleeding and trapped air in the system.
Coolant capacity
6.6 US qt (6.2 liters, 5.5 Imp qt)
7. Put the air vent plug back on and tighten firmly.
HG0115
Rubber gaskets
8. Put the radiator cap back on and tighten firmly. At this time, make
sure that the rubber gasket in the radiator cap is correctly in place.
9. Start and run the engine for more than five minutes at 2,000 to 3,000
rpm.
To Next Page
Loading...
Need help?
General
