IMPREZA U.S.A. (E)
6-20
the map shown above for the setting most appropriate for your loca-
tion.
1) Press the “ADJ” switch for 5 seconds or more.
2) Press the “YSET” or “B” to obtain the correct setting.
“YSET”: “0” & “W”, “5” & “E”, “10” & “E”, ...
“B”: “10” & “W” → “15” & “W”, ...
3) Press the “ADJ” switch again to save the setting and return the
system to the original display.
2. Direction setting
If the vehicle icon is blinking at any time, the following adjustment is
required to recalibrate the compass.
NOTE
This will happen due to the magnetic field interference as
described previously.
HS6011BBHS6010BA
1) Press the “ADJ” switch for the compass setting mode.
NOTE
D The compass starts blinking in this mode.
D This mode can be canceled by pressing the “ADJ” switch
again.
2) Make certain that it is safe to do so and then drive the vehicle in a
circle until the compass stops blinking. You may have to complete
more than one circle to perform this calibration.
To Next Page
Loading...
