FORESTER (72F) NA (E) A8040B
5-18
n Fader and balance control
The volume control dial
7 normally function as volume control. The
dial become the controls for Fader or Balance when you select the
appropriate fader and balance control mode.
Choose desired setting for each mode by turning the volume control
dial. The control function returns to volume control mode after about 5
seconds.
To change control modes: Each brief press of the “FAD/BAL” button
6 changes control modes in the following sequence starting from
fader control mode. (When the radio is turned on, the control mode is
in the volume control.)
Balance Fader Volume
(BAL) (FAd) (VOL)
n Display illumination dimness cancellation
The brightness of the radio display dims when the light switch is in the
“p” or “w” positions. If this makes the display difficult to read,
press the volume dial for more than two seconds to return the display
to original brightness.
B FM/AM selection button
Push the “FM”
1 or “AM” 2 button when the radio is off to turn on the
radio.
Push the “FM” or “AM” button when the radio is on to select FM1, FM2
or AM reception.
B Stereo indicator
The stereo indicator “ST” will come on when an FM stereo broadcast
is received.
To Next Page
Loading...
