FORESTER (72F) NA (E) A8040B
11-50
J Fog light (if equipped)
CAUTION
Halogen light bulbs become very hot while in use. If you touch
the bulb surface with bare hands or greasy gloves, finger prints
or grease on the bulb surface develop into hot spots, causing the
bulb to break. If there are finger prints or grease on the bulb sur-
face, wipe them away with a soft cloth moistened with alcohol.
B To remove and install the fog light protector
HS0214HS0213
1
2
1. Unhook the lower part of the fog light protector by pulling the hook
down.
2. Pull the protector to remove it.
3. To install the protector, first insert the upper part of the protector
into the gap between the fog light and body, then push the lower part
of the protector until it clicks.
4. Make sure that the protector is locked in place by pulling it lightly.
To Next Page
Loading...
