IMPREZA U.S.A. (E) A1820BE–A
3
Instruments and controls
3-13
– CONTINUED –
lever.
first position
Parking lights, instrument panel illumination, tail lights, side marker
lights and license plate light are on.
second position
Headlights, parking lights, instrument panel illumination, tail lights,
side marker lights and license plate light are on.
B High/low beam change (dimmer)
To change from low beam to high beam, push the turn signal lever
forward. When the headlights are on high beam, the high beam indi-
cator light “a” on the instrment panel is also on.
To switch back to low beam, pull the lever back to the detent position.
B Headlight flasher
CAUTION
Do not hold the lever in the flashing position for more than just a
few seconds.
To flash the headlights, pull the lever toward you and then release it.
The high beam will stay on for as long as you hold the lever. The
headlight flasher works even though the lighting switch is in the “OFF”
position.
When the headlights are on high beam, the high beam indicator light
“a” on the instrment panel also comes on.
B Daytime running light system (for CANADA models)
WARNING
The tail lights, parking lights, and side marker lights are not
turned on by the daytime running light system. The light switch
must always be turned to the “a” position when it is dark out-
side.
To Next Page
Loading...
