IMPREZA U.S.A. (E) A1820BE–A
2
Seat, seat belt and SRS airbag
2-23
– CONTINUED –
HS2002BA
1. Set the child restraint system in the center seating position.
2. Run the 2-point type seat belt through or around the child restraint
system following the instructions provided by its manufacturer.
3. Insert the tongue plate into the buckle.
4. Tighten the seat belt.
5. Before having a child sit in the child restraint system, move it back
and forth to check if it is firmly secured. Sometimes a child restraint
can be more firmly srcured by pushing it down into the seat cushion
and then tightening the seatbelt.
If the child restraint system requires a top tether, latch the hook onto
the top tether anchor and tighten the top tether. See “Top tether an-
chorages” for additional instructions.
6. To remove the child restraint system, press the release button on
the seatbelt buckle.
B Installing child restraint systems in the 3-point type seat belt
position
CAUTION
When you install a child restraint system, follow the manufactur-
er’s instructions supplied with it. After installing the child re-
straint system, check to ensure that it is held securely in posi-
tion. If it is not held tight and secure, the danger of your child
suffering personal injury in the event of an accident may be in-
creased.
To Next Page
Loading...
