11-70
Maintenance and service
4. Remove the bulb from the socket by pushing it and
turning counterclockwise. Install a new bulb in the
socket.
5. Set the bulb socket into the headlight assembly and
turn it clockwise until it locks.
6. Set the headlight assembly into the vehicle body.
Tighten the mounting screws.
Rear combination lights
Rear combination lights are composed of the rear turn
signal/brake/tail light and back up lights.
T Rear turn signal/Brake/Tail and Back up lights
The rear turn signal/brake/tail light is one bulb with two
filament types.
If any one of them malfunctions, replace the bulb with
a new one.
1. Open the tailgate.
2. Pry the cover from the side of the rear combination
light.
UBB020BA
UBB083BA
To Next Page