Subaru 2007 Impreza - Page 58

* Refer to STIS (Subaru Technical Infromation System) *** New Feature
2007 Legacy Page 58
July 2006
2007 New Model Update (916)
NOTE: SDI POWER WILL TURN ON AUTOMATICALLY WHEN THE DIAGNOSIS CABLE IS
CONNECTED TO THE VEHICLE. IF THE POWER OF THE SDI DOES NOT LIGHT, TURN
ON THE VEHICLE’S IGNITION SWITCH OR START THE ENGINE, AND THEN PRESS
THE SDI [PWR] KEY AND CHECK AGAIN TO SEE IF THE PWR LED OF THE SDI
LIGHTS.
3. Use the USB cable to connect the SDI to the PC.
4. Turn on the vehicle’s ignition switch.
5. Double-click the SSMIII icon on the PC screen to start up the application.
6. On the Main Menu that appears on the display, select [Each System Check] and
then press the Enter key or left-click with the mouse.
7. On the System Selection Menu, select [Brake Control System] and then press the
Enter key or left-click with the mouse.