* Refer to STIS (Subaru Technical Infromation System) *** New Feature
2007 NMUD Page 80
August 2006
2007 New Model Update (916)
POWER SEAT MEMORY CALIBRATION PROCEDURE
CALIBRATION PROCEDURE
If the seat is removed or replace with new one, Memory Power Seat System will need to be
recalibrated.
1. With the transmission selector lever in the “P” position.
2. Press and hold the SEATBACK switch to the upright MOST position until the beep
sounds once.
3. Press and hold the SLIDE switch to rear MOST position until the beep sounds
once.
4. Press and hold the TILT switch to lower MOST position until the beep sounds
once.
5. Press and hold the LIFTER switch to lower MOST position until the beep sounds
once.
6. When you release the LIFTER switch, the beep sounds three times (OK signal).
To Next Page
Loading...
