Black plate (61,1)
北米Model "A2470BE-A" EDITED: 2010/ 3/ 24
! To hook the top tether
CAUTION
Always remove the head restraint
when mounting a child restraint
system with a top tether. Failure to
do so may prevent the top tether
from being fastened tightly.
! Legacy
1. Fold down the rear seatback for the
window side seating position. Refer to
“Folding down the rear seatback” F1-9.
2. Remove the head restraint at the
seating position where the child restraint
system has been installed with the seat-
belt or lower anchorages; lift up the head
restraint while pressing the release button.
Store the head restraint in the trunk. Avoid
placing the head restraint in the passen-
ger compartment to prevent it from being
thrown around in the passenger compart-
ment in a sudden stop or a sharp turn.
3. Open the cover flaps to use the
anchorages.
4. Fasten the top tether hook of the child
restraint system to the appropriate upper
anchorage.
5. Tighten the top tether securely.
! Outback
Seat, seatbelt and SRS airbags 1-37
– CONTINUED –
1
To Next Page
Loading...
