Subaru 2015 Outback - Starting and Stopping the Engine; Push-Button Ignition System; Electronic Parking Brake; Ignition Switch Operation

4
◆
Some functions are available on certain models.
◆
For detailed operating and safety information, please refer to your Owner’s Manual.
Start/ Stop engine
Starting engine:
1.
Carry the access key, and sit in the driver’s seat.
2.
Apply the parking brake.
3.
Shift the select lever in the
P
position (CVT models)
or shift lever in neutral (MT models).
4.
Depress the brake pedal (CVT models) or brake
pedal and clutch pedal (MT models) until the
indicator on the push-button ignition switch turns
green.
5.
While depressing the brake pedal (CVT models) or
clutch pedal (MT models), press the push-button
ignition switch.
To stop engine:
1.
Stop the vehicle completely.
2.
Move the select lever to the
P
position (CVT models) or shift lever in neutral (MT models).
3.
Press the push-button ignition switch.
Every time the button is pressed without depressing the brake pedal, the power is switched
in the sequence of
OFF
➞
ACC
➞
ON
➞
OFF
.
OFF
(Turned off)
ACC
(Orange)
ON
(Orange)
The key can be turned from
ACC
to
LOCK
only when the key is pushed in while turning
it (all models) and the select lever is in the
P
position (CVT models).
Push-button ignition switch (if equipped)
Electronic parking brake switch Ignition switch (if equipped)
*The design may be slightly different from the illustration
depending on the models.
Operation
indicator
Apply
Release