18
system is fastened by changing the
seatbelt from ELR mode to ALR mode.
1. Prepare the rear seat head restraint
where a child restraint system is intended
to be installed in the following way.
– When a child restraint system is in-
stalled, remove the rear seat head re-
straint.
2. Adjust the seatback to the upright posi-
tion.
3. Place the child restraint system in the
rear seating position.
4. Run the lap and shoulder belt through
or around the child restraint system follow-
ing the instructions provided by its manu-
facturer.
– When a child restraint system is in-
stalled on the rear center seating posi-
tion, pass the rear center seatbelt
through the belt guide properly. For in-
formation about using the seatbelt
guide, refer to the “Fastening the
seatbelt” section in this manual.
5. Insert the tongue plate into the buckle
until you hear a click.
Store the head restraint in the cargo
area. Avoid placing the head re-
straint in the passenger compart-
ment to prevent it from being thrown
around in the passenger compart-
ment in a sudden stop or a sharp
turn.
101743
When you intend to install a child re-
straint system on the rear center
seating position, if the child re-
straint system does not fit snugly
against the contours of the rear cen-
ter seat cushion, install the child re-
straint system on the window-side
seating position to be safe.
101599
101512
B1301AE-A.fm 18 ページ ２０１６年８月２９日 月曜日 午前１０時４分
To Next Page
Loading...
