3-8
Instruments and controls/Meters and gauges
! Type B combination meter
1. Turn the ignition switch to the “LOCK”/
“OFF” or “Acc” position.
2. Press the trip knob to show “
” or
“
” on the trip meter display.
The display can be switched as shown in
the following illustration by pressing the
trip knob.
*
1
: “ ” or “ ” and “ ” or “ ” cannot
be displayed when the ignition switch is
in the “ON” position.
*
2
: MT models only
3. To change the current setting, press
the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
. Your vehicle’sinitialmovement
setting of the meter/gauge needles
has been set for activation “
” at
the time of shipment from the factory.
. It is not possible to change the initial
movement setting of the meter/gauge
needles when the ignition switch is in
the “ON” position. Change the setting
when the ignition switch is in the
“LOCK”/“OFF” or “Acc ” position.
& Speedometer
The speedometer shows the vehicle
speed.
& Odometer
Type A
1) U.S. spec. models
2) Except U.S. spec. models
Type B
This meter displays the odometer when
To Next Page
