Subaru LEGACY Quick Reference Guide

3
Getting
Started
Instrument
Panel
Gauges
Personalize Controls While
Operating
Safety / In Case
of Emergency
Additional
Information
2
3
Getting
Started
Remote Keyless Entry
Lock/Arm
t1SFTTUPMPDLBMMEPPST
and trunk and activate the
security alarm.
t*GBOZPGUIFEPPSTPSUIF
trunk are not fully closed,
an electronic chirp will
sound ve times and the
hazard lights will ash ve
times to alert you that the
doors or the trunk are not
properly closed.
t5PBDUJWBUFUIFWFIJDMFýOEFS
function, press three times
(within ve seconds).
If you are within 30 feet of
the vehicle, the horn will
sound one time and the
hazard lights will ash
three times.
Unlock/Disarm
t1SFTTPODFUPVOMPDL
the driver’s door.
t1SFTTUXJDFXJUIJOýWF
seconds) to unlock all doors.
t8IFOUIFi6OMPDL%JTBSNw
button is pressed, the dome
and map lights will illuminate
if the dome light switch is in
the middle position.
Opening the
Trunk Lid
Press and hold to unlock the
trunk lid. An electronic chirp will
sound twice and the hazard
lights will ash twice.
Panic Alarm
t1SFTTPODFBOEUIFIPSO
will sound and the hazard
lights will ash.
t1SFTTBOZCVUUPOPOUIF
remote to deactivate.
Immobilizer
When the security alarm is
activated, the immobilizer
interrupts the starter motor
to prevent an intruder from
starting your vehicle without
a registered key.
Seating
10-Way Power Driver’s Seat
(if equipped)
1. Forward/Backward, Angle and Height
Move the switch toward the front or rear to
move the seat forward or backward. Pull the
switch up or push down on the front of the
switch to adjust the angle of the seat cushion.
Pulling the switch straight up or pushing the
switch straight down will adjust the height of
the entire seat cushion.
2. Seatback
Move the switch in the corresponding direction
to adjust the angle of the seatback.
3. Lumbar Support
Press the front part of the switch to increase
lumbar support; press the rear part of the
switch to decrease lumbar support.
Heated Seats
(if equipped)
Press the switch in the
corresponding direction for
the desired seat temperature.
To turn off the seat heater,
slightly press in the opposite
direction of the current position.
Rear Seat
Release Lever
Open the trunk lid. Pull the
release lever on the seat side
that you want to fold down. To
return the seatback to its original
position, raise the seatback until
it locks into place making sure
that it is securely locked.
3
Ins
I
tru
men
t
Panel
Gau
G
ges
Per
P
son
ali
li
z
e
Con
C
tro
t
ls
l
Whi
Whi
le
l
Operatin
g
Saf
Sf
ety
t
/
/
In
I
Cas
C
e
of Emer
g
ency
Add
Add
iti
ii
ona
l
l
Information
3
Get
ting
Get
ting
Starte
d
Started
e
o
n.
e
f
t
ion
e
Getting
Started
3
2
1

Subaru LEGACY Specifications

General

Brand	Subaru
Model	LEGACY
Category	Automobile
Language	English