7
This appliance should be maintained and cleaned frequently. For your safety, ensure to unplug the socket from
the main power source before cleaning.
Heavy frost will influence the refrigeration of the appliance and increase the energy consumption. Thus,
defrosting is needed when the frost is as thick as 5 mm. The process for manual defrost are listed as follows:
• Take all the food out of the
compartment;
• Remove the shelf;
• Unplug the power cord;
• Open the doors and wait for thawing;
• Wipe the defrost water with a dry cloth.
❑ Interior maintenance
Clean the interior of the appliance with clean water or a neutral non-haz cleaner. Clean warm water works best to
wipe the surfaces clean with a damp cloth
❑ Maintenance of the door gasket
It is easy to cause damage to the door gaskets if it becomes dirty. Wipe the rubber door gasket seal with a warm
cloth to remove any dirt or stains
❑ Outer maintenance
Keep the exterior clean with a piece of dry cloth ,clean it with neutral non-haz
cleaner if necessary.
In case of a power failure, the refrigerator can store food normally for several hours.
❑ During power failure
If you experience a power failure, do not put additional food in the appliance and reduce the frequency of door
opening.
❑ During vacation
Please remove food in fridge before a shot holiday. Close the door firmly. If you have a longer holiday, please
remove all the food and switch off the power. After defrosting, clean the appliance and wipe it dry, and leave
the door open to prevent unwanted smells
❑ Not in use
Warning: Do not use any other equipment or method to assist the defrost process. It may cause
damage to the cooling system.
If the refrigerator has stopped being used for a long time, please unplug from the outlet and clean the appliance.
The door should be kept open in order to prevent unpleasant smell
Attention: In a general working conditions, do not restart the power immediately, please leave at at least 5
minutes before powering back on.
To Next Page
Loading...
