5
Before you start, make sure that Bluetooth is
enabled on your Bluetooth enabled device, and
that it is visible to other devices
1. Initially, Bluetooth is disabled on the speaker, and
the Bluetooth light will be off
2. Press and hold the Bluetooth button for around
2 seconds, until you hear a tone and the
Bluetooth light starts to flash. The speaker
is now in pairing mode.
3. The speaker will appear as ‘SZPA-L610X’ in
the list of available devices on your device’s
Bluetooth settings screen. Select this device to
begin pairing.
4. When pairing is successfully completed,
the speaker will play a tone and the light
will remain lit.
5. The speaker and your device will then
automatically connect.
6. To disconnect the speaker from your device,
press and hold the Bluetooth button for 2
seconds. You will hear a tone from the speaker
and the Bluetooth light will go off.
7. To reconnect your device to the speaker, press
and hold the Bluetooth button for 2 seconds.
You will hear a tone from the speaker and the
Bluetooth light will flash for a few seconds.
When connection is complete the Bluetooth light
will remain lit and you will hear another tone
from the speaker. If the speaker doesn’t connect
automatically, tap ‘SZPA-L610X’ in the list on
your device.
BLUETOOTH PAIRING
To Next Page
Loading...
Need help?
General
