EXTRACTION MODE
To get into this mode, repeatedly press the button FLOW (F) to see the image below on
display.
When pressing FLOW button the mode will change in the sequence MASTER-SLAVE AIR
FLOW, SLAVE-MASTER AIR FLOW, EXTRACTION, INTAKE, MASTER-SLAVE AIR
AIRFLOW…).
In this mode the IMPELLER button (V) is active to select the desired speed.
By pressing the specific function button all the units will constantly run in extraction with the
possibility to change the speed as required.
Advise for use
Recommended mode to extract a lot of stale air, to the disadvantage of the heat
recovery, when rooms are very crowded like during parties, anniversaries…
To Next Page
Loading...
Need help?
General
