INSTALLATION – CONFIGURATION
SOLO
Direct connection, the product doesn’t need any configuration.
ADVANCED
For configuration, please follow the instructions below, taking into consideration that the first
unit installed will be the MASTER and all the others in sequence SLAVE OPPOSITE to
MASTER and SLAVE SAME AS MASTER UNIT.
WARNING: the MASTER is the only unit receiving commands from control device, that will
detect the ambient conditions through the sensors and thus controlling all the system.
In case of large indoor space or systems on multi-floors, it is recommended to split the
system into zones (living area-sleeping area or 1
st
floor-2
nd
floor) for easier control of the
units.
To Next Page
Loading...
