79
1.0 INTRODUCTION
This technical manual contains operating descriptions, installation processes, assembly,
maintenance, and technical data addressed exclusively to qualified staff engaged in installation and
maintenance of the product.
1.1 INTENDED USE
The product is manufactured according to the book and installed to allow for constant exchange of
the room air. The regenerator can be installed in homes and, generally, in domestic and public
places.
The product is provided with a heat exchanger of ceramic type that accumulates heat during the air
extraction from the room, while during the release of air from the outside, the device transfers the
heat stored in the exchanger, to the incoming air.
The product must be installed at the wall. The tube inside of which the ceramic exchanger is
positioned, is equipped for walls with a maximum of 500mm of thickness; the tube can be
shortened to a minimum of 250mm. (With prolungation > 3m)
The air extracted or inlet by the product, must not contain flammable or explosive mixtures,
chemical vapors, dust, oils, and other pathogenic substances.
To Next Page
Loading...
