To Next PageTo Next Page
Need help?Do you have a question about the Sullair DMD-25 and is the answer not in the manual?
General| Model | DMD-25 |
|---|---|
| Inlet Temperature | 120°F (49°C) maximum |
| Power Supply | 115V/1Ph/60Hz or 230V/1Ph/50Hz |
| Inlet Pressure Range | 100-250 PSIG |
| Inlet Temperature Range | Up to 120°F (49°C) |
| Air Flow | 25 scfm (0.71 m³/min) |
End user and operator must observe all national, state, and local safety regulations for pressure vessels.
Highlights critical hazards associated with compressed air and equipment operation, emphasizing unauthorized use.
Details the intended use of the dryer for compressed air moisture removal and compliance with installation conditions.
Guidelines for safe operation of pressure equipment, including limits, maintenance, and documentation.
Key considerations for dryer installation, including flow capacity, mounting, piping, and pressure settings.
Provides operating and electrical specifications for the DMD dryers, including pressure, temperature, and voltage.
Steps for initially starting the dryer, including air supply and valve checks.
Procedure for starting the dryer when a by-pass line is not used.
Steps to safely shut down and depressurize the dryer before maintenance or isolation.
General rules for performing maintenance, including safety precautions and approved parts.
Troubleshooting steps for poor dewpoint, including inlet conditions and desiccant issues.
Troubleshooting for electrical faults and failure to purge, including hardware and valve issues.
Troubleshooting for outlet air flow stops and constant depressurisation issues.
