Section 3
SPECIFICATIONS
10
Mixing of other fluids within the compressor will
void all warranties.
DO NOT MIX DIFFERENT TYPES OF FLUIDS.
Contamination of non-detergent mineral fluids with
traces of ATF or detergent motor fluids may lead to
operational problems such as foaming, filter plug-
ging, orifice or line plugging. Flushing is required if
changing to a different lubricant.
Flush system when switching lubricant brands.
When ambient conditions exceed those noted or if
conditions warrant use of “extended" life lubricants
contact Sullair for recommendation.
Sullair encourages the user to participate in a fluid
analysis program. This could result in a fluid change
interval that is different from those stated in this
manual.
Table 3-1 Lubrication Guide
AMBIENT LUBRICANT FLUID FLUID FILTER SEPARATOR
TEMPERATURE CHANGE CHANGE CHANGE
-23ºC to +45ºC Sullube A , B C A
A - 8,000 Hours or once a year.
B - When required by fluid analysis or known contamination.
C - Every 1000 hours.
Figure 3-2 Center of Gravity
Figure 3-1 Fluid Fill
To Next Page
Loading...
