SAFETY INSTRUCTIONS
GENERAL INSTRUCTIONS
x
Prior to using these tools, become familiar with any local
regulations. It is essential to carry out any specific safety instructions
concerning the site or place of operation.
x
Make sure that only persons authorized to use compressed air equipment
have access to the work area. Only trained persons over 18 years of age are
authorized to use these tools.
x
Always wear protective clothing and equipment (PPE) against:
o
Atmospheric exposure: appropriate, resistant, waterproof clothing.
Never wear baggy clothes, rings or chains, which could become caught in
moving parts or tools.
o
Heat or cold, tool vibrations: gloves.
o
Noise: hearing protectors.
o
Shocks: Helmet, safety shoes with non-slip soles.
o
Projectile risks: safety glasses, face guard.
o
Pollution: facemask.
x
Never service these tools using dangerous products: gas/oil (diesel) petrol
(gasoline) or any volatile ingredients. (explosion risk).
x
Keep these tools clean, especially handles.
x
Follow OSHA standards and/or any applicable Federal, State or Local codes
and regulations where they apply.
PRIOR TO START UP
x
Check that the tool is in good condition: no cracks, fissures or scaling.
x
Make sure all bolts are undamaged and correctly tightened and that safety
devices fitted to the equipment are in position and function correctly.
x
Check for sleeve, shank and collar wear, which if too high could cause the
ejection of the steel (bit) or other machine parts.
x
Make sure that the clamp or mechanism retaining the steel (bit) is in good
condition.
x
Only use steel (bit) in accordance with manufacturer’s specifications.
x
Check steel (bit) sharpness, shank condition and wear. Check steel (bit)
grinding and steel (bit) clearances and that the blowhole is in good condition
for drilling hammers.
x
Check the air hose, which must not be cracked or have any deep abrasions
and make sure all gaskets are in place and in good condition.
x
Make air hose connections safe from accidental disconnection by using
appropriate safety clips.
SAFETY INSTRUCTIONS
4
02250218-225 R02
©
2015 Sullair, LLC.
Update: September 12 2015
Subject to EAR, ECCN EAR99 and related export control restrictions.
To Next Page
Loading...