Sullair RD-0850-460-3-60-A User Manual

Failure to follow the instructions
and procedures in this manual or,
misuse of this equipment will
VOID its warranty!
WARRANTY NOTICE
USER/SERVICE MANUAL
REFRIGERATED DRYERS
RH—HIGH TEMPERATURE
RN—NON-CYCLING
RD—DIGITAL CYCLING
PART NUMBER:
KEEP FOR
FUTURE
REFERENCE
©
SULLAIR CORPORATION
02250195-401 R00
The information in this manual is current
as of its publication date, and applies to
compressor serial number:
(RH) 0611SA0198
(RN) 4810SA0001
(RD) 0711SA0263
and all subsequent serial numbers.

Sullair RD-0850-460-3-60-A Specifications

General

Model	RD-0850-460-3-60-A
Category	Dryer
Capacity	850 CFM
Voltage	460 V
Phase	3
Frequency	60 Hz
Maximum Inlet Temperature	120°F
Maximum Operating Pressure	150 psig
Pressure Dew Point	38°F
Type	Refrigerated

Summary

Section 1 Safety

1.1 Safety Information

General safety instructions and regulations for operating and maintaining the dryer.

Section 2 RH Series Refrigerated High Temperature Compressed Air Dryer

2.4 Safety Regulations

Detailed safety regulations for installation, transportation, positioning, and operation of the dryer.

2.6 Dryer Operation Procedure

Step-by-step instructions for starting and shutting down the dryer for first-time and daily use.

2.13 Wiring Diagram

Electrical wiring diagram for the RH Series High Temperature dryers.

2.14 Troubleshooting

Common problems, causes, repairs, and comments for troubleshooting dryer issues.

Section 3 RN & RD Series Refrigerated Non-Cycling Compressed Air Dryer

3.3 Safety Instructions

Safety regulations and instructions for operating and installing RN & RD series dryers.

3.11 Principle of Operation

Explanation of the overall operating principle of the refrigerant and compressed air circuits.

3.15 Operating Precautions

Important precautions to take before and during dryer operation, including parameter verification.

3.16 Installation

Step-by-step instructions and considerations for installing the dryer, including by-pass valves and filters.

3.17 Steps to Undertake Before Operating

Checklist of essential steps to perform before starting the dryer operation, including manual review and safety.

3.18 Operating Procedures

Detailed sequence of operations for starting up and running the dryer after installation or shutdown.

3.19 Startup and Shut Down Procedure

Procedures for safely starting up and shutting down the dryer, including pre-heating and inactivity recommendations.

3.48 Wiring Diagram—RN5-10-15-20-25

Electrical wiring diagram for RN5-10-15-20-25 models.

3.49 Wiring Diagram—RN35-50-75-100

Electrical wiring diagram for RN35-50-75-100 models.

3.50 Wiring Diagram—RN125-150

Electrical wiring diagram for RN125-150 models.

3.51 Wiring Diagram—RN175

Electrical wiring diagram for RN175 models.

3.52 Wiring Diagram—RN200

Electrical wiring diagram for RN200 models.

3.53 Wiring Diagram—RN250-325

Electrical wiring diagram for RN250-325 models.

3.54 Wiring Diagram—RN250-325 (230-3-60-A)

Electrical wiring diagram for RN250-325 (230V) models.

3.55 Wiring Diagram—RN250-325 (230-3-60-A)

Electrical wiring diagram for RN250-325 (230V) models.

3.56 Wiring Diagram—RN250-325 (460-3-60-A, 400-3-50-A)

Electrical wiring diagram for RN250-325 (460V/400V) models.

3.57 Wiring Diagram—RN250-325 (460-3-60-A, 400-3-50-A)

Electrical wiring diagram for RN250-325 (460V/400V) models.

3.58 Control Circuit—RN250-325

Control circuit diagram for RN250-325 models.

3.59 Power Circuit—RN250-325

Power circuit diagram for RN250-325 models.

3.60 Maintenance

Procedures for performing maintenance on the dryer, divided by technician and user tasks.

3.60.1 Maintenance by an Engineer/Technician

Maintenance tasks for qualified engineers/technicians, emphasizing safety and proper tools.

3.60.2 Maintenance by the User

Regular maintenance tasks to be performed by the user, including cleaning and checks.

3.62 Troubleshooting

Troubleshooting guide for common dryer problems, including causes, repairs, and comments.

Section 4 E-680 Controller for Refrigerant Dryers

4.2 Operation

Operating instructions and front panel view of the E-680 controller, including buttons and display.

4.2.2 Normal Operation

Description of the normal operation screen and display, showing temperatures and status.

4.2.3 Configuration Mode

Instructions for entering and navigating the configuration mode of the controller, including security codes and parameter pages.

4.34 Wiring Diagram—RD400 (230-3-60-A)

Electrical wiring diagram for RD400 (230V) models.

4.35 Wiring Diagram—RD400 (230-3-60-A)

Electrical wiring diagram for RD400 (230V) models.

4.36 Wiring Diagram—RD400 (460-3-60-A, 400-3-50-A)

Electrical wiring diagram for RD400 (460V/400V) models.

4.37 Wiring Diagram—RD400 (460-3-60-A, 400-3-50-A)

Electrical wiring diagram for RD400 (460V/400V) models.

4.38 Wiring Diagram—RD500/700 (230-3-60-A)

Electrical wiring diagram for RD500/700 (230V) models.

4.39 Wiring Diagram—RD500/700 (230-3-60-A)

Electrical wiring diagram for RD500/700 (230V) models.

4.40 Wiring Diagram—RD (500/700/850-1000-1200-1600-2000-2400-3000-3800-5000-6000) 460-3-60-A, 400-3-50-A

Electrical wiring diagram for RD500-6000 (460V/400V) models.

4.41 Wiring Diagram—RD (700-850-1000-1200-1600-2000-2400-3000-3800-5000-6000) 460-3-60-W, 400-3-50-W

Electrical wiring diagram for RD700-6000 (460V/400V) models.

4.42 Wiring Diagram—RD700-850 (230-3-60-W)

Electrical wiring diagram for RD700-850 (230V) models.

4.43 Wiring Diagram—RD700-850 (230-3-60-W)

Electrical wiring diagram for RD700-850 (230V) models.

4.44 Wiring Diagram—RD (700-850-1000-1200-1600-2000-2400-3000-3800-5000-6000) 460-3-60-W, 400-3-50-W

Electrical wiring diagram for RD700-6000 (460V/400V) models.

4.45 Wiring Diagram—RD (700-850-1000-1200-1600-2000-2400-3000-3800-5000-6000) 460-3-60-W, 400-3-50-W

Electrical wiring diagram for RD700-6000 (460V/400V) models.

4.46 Control Circuit—RD400-500-700-850-1000-1200-1600-2000-2400-3000-3800-5000-6000

4.47 Power Circuit—RD400-500-700-850-1000-1200-1600-2000-2400-3000-3800-5000-6000