Page 2 of 34
FOREWORD
The compressed air dryer systems have been designed and manufactured to ensure that maximum
safety and performance is achieved. It is expected that users of these systems will employ safe
working practices and ensure that when installing, commissioning, operating or maintaining the
equipment, any legal requirements are fulfilled. For example, in the UK, users should refer to the
Health and Safety Act, 1974.
All ancillary equipment such as pipework, valves, fittings etc., must be suitable for the pressures and
capacities involved.
Replacement parts are available from your distributor or the manufacturers ( see back page for
information). The adoption of a regular servicing policy is strongly recommended and will result in
ensuring that a high performance is achieved. Serial numbers and customer order numbers should
be referred to in any communication. (Serial numbers can be found on the identification plate on the
left hand side of the instrumentation shroud). The figure number and the appropriate diagram in this
manual and the item number (shown in circle,) will also assist in part identification.
Any warranty will be invalidated if the dryer is not commissioned in accordance with the
manufacturers recomendations or non-approved parts substituted. Substitute parts could reduce the
performance or service life in addition to creating potential hazards.
The manufacturers reserve the right to modify the contents of this manual without notice. The data
given is a guideline to users and in no way binding on the manufacturers.
BEFORE SERVICING OR DISMANTLING ALL PRESSURE MUST BE RELEASED
FROM THE SYSTEM AND ITS ASSOCIATED PIPEWORK AND ANY ELECTRICAL
SUPPLY ISOLATED.
To Next Page
Loading...
